Power & Control Cabinet Assembly
We can accept assembly work for all electrical cabinets with automation and motion control systems. Because our team has special knowledge and expertise. by the assembly of electrical cabinets, We have carried out the design of the internal equipment location and also the electrical protection system. We will take into account the installation area and the convenience of employees is also the main concern.
Power & Control Cabinet
Normally Assembly Process
- Manually positioning each component on the back panel.
- Measuring, marking and taping their locations.
- Punching or sawing holes for the components.
- Manually drilling and tapping holes for mounting hardware.
- Wiring the panels with mark by Electricians.
Electrical Communicate & Safety Testing
Two of the main targets in any panel test are the checking of the secondary protections and all the associated wiring and signals of the whole protection system, being essential to carry out functional performance tests for finding reliability deficiencies before any problem happens. Some electrical panel test procedures for ensuring the effectiveness of the different elements in the panel and their joint operation are the following:
- Protection Panel Test
- Safety Equipment Test
- Schematic Wiring Check
- IP/Other Protocol Communication Link Check
- Ground Test
Cabinet Installation / Transportation
After assembling the electrical cabinet We are responsible for the transportation of water and electric cabinets they can install in the area according to the customer’s requirements.
We have specialized tools to safely transport electrical cabinets to production areas where in hard-to-reach areas can be done under a co-op decision for a safe method.
More than Electrical Cabinet Installation
- Programming and Configuration System
In the automatic control system, there must be a complete program and configuration of the system. And because of the complexity, it takes specialists to operate. We are ready to provide programming and setup services along with cabinet assembly work.
By devices such as PLC Controller, Motion Drive, AC Drive, I/O Module, Sensor and other common systems, we can confabulate it.
- Power and Control wiring to Other System
In the machine control system, Typically there is a communication connection with other collaborative systems. We can perform this task when other systems have a clear connection point or a technician can tell. which this work will be wiring on the original wire way or adding a new one.
